Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Lexus SC 430FACTORY OEM SERVICE PROCEDURE
Inner Rear View Mirror: Replacement
HINT:
The installation procedures are the removal procedures in reverse order. However, only installation procedures requiring additional information are included.
- REMOVE MAP LAMP ASSY (See REPLACEMENT )
- REMOVE INNER REAR VIEW MIRROR STAY HOLDER COVER
- Using a screwdriver, remove the holder cover.
HINT:
Tape the screwdriver tip before use.
- Using a screwdriver, remove the holder cover.
- REMOVE INNER REAR VIEW MIRROR ASSY
- Disconnect the mirror connector.
- Remove the mirror by turning the stay part of the mirror counterclockwise.
- INSTALL INNER REAR VIEW MIRROR ASSY
- Match the claw of the stay part of the mirror with the cut part of the base.
- Turn the stay part of the mirror clockwise so that the stay comes to the original position, and then install the mirror.
- Connect the mirror connector.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
