Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Lexus RX 330 FWDFACTORY OEM SERVICE PROCEDURE
Knock Sensor: Removal
WARNING: This page is about a different car, the 2007 Lexus RX 350. However, it is still accessible from the selected car via links, so may be relevant.
- DISCHARGE FUEL SYSTEM PRESSUREÂ
(See REMOVAL )
- REMOVE V-BANK COVER SUB-ASSEMBLYÂ (See REMOVAL )
- DRAIN ENGINE COOLANTÂ (See ON-VEHICLE INSPECTION )
- REMOVE WINDSHIELD WIPER LINK ASSEMBLYÂ
HINT:
(See REMOVAL )
- REMOVE COWL TOP PANEL OUTER SUB-ASSEMBLYÂ (See REMOVALÂ )
- REMOVE AIR CLEANER CAP SUB-ASSEMBLYÂ (See REMOVALÂ )
- REMOVE AIR CLEANER CASE SUB-ASSEMBLYÂ (See REMOVALÂ )
- REMOVE INTAKE AIR SURGE TANK ASSEMBLYÂ
- Disconnect the 2 water by-pass hoses from the throttle body.
- Disconnect the vapor feed hose.
- Disconnect the throttle body connector and clamp.
- Disconnect the ventilation hose No. 2.
- Disconnect the union to check valve hose.
- Disconnect the connector.
- Using a 5 mm socket hexagon wrench, remove the 4 bolts.
- Remove the 2 nuts, 2 bolts and intake air surge tank.
- Remove the gasket from the intake air surge tank.
- REMOVE FUEL TUBE SUB-ASSEMBLYÂ (See REMOVAL )
- REMOVE INTAKE MANIFOLDÂ (See REMOVAL )
- REMOVE KNOCK CONTROL SENSORÂ
- Disconnect the 2 knock sensor connectors.
- Remove the 2 bolts and then remove the 2 knock sensors.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
