2005 Lexus RX 330 FWDFACTORY OEM SERVICE PROCEDURE

Section 537 (Engine Control System): ECM: Removal

WARNING: This page is about a different car, the 2007 Lexus RX 350. However, it is still accessible from the selected car via links, so may be relevant.
  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
  2. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY 
  3. REMOVE ECM 
    1. Disconnect the 5 ECM connectors.
    2. Disconnect the wire harness clamp.
    3. Remove the 2 nuts and ECM.
    4. Remove the 2 screws and the ECM No. 1 bracket from the ECM.
    5. Remove the 2 screws and the ECM No. 2 bracket from the ECM.
    6. Remove the 2 screws and the ECM No. 3 bracket from the ECM.
      Fig 1: Locating ECM Bracket Screws
      G05268344Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.