2005 Lexus RX 330 FWDFACTORY OEM SERVICE PROCEDURE

Accelerator Pedal Rod: Installation

WARNING: This page is about a different car, the 2007 Lexus RX 350. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL ACCELERATOR PEDAL ROD 
    NOTE:
    • Avoid physical shock to the accelerator pedal assembly.
    • Do not disassemble the accelerator pedal assembly.
      Fig 1: Locating Accelerator Pedal Position Sensor Connector And Nuts
      G05136385Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Install the accelerator pedal rod with the 2 nuts.

      Torque: 4.9 N*m (50 kgf*cm, 43 in.*lbf) 

    2. Connect the accelerator pedal position sensor connector.
  2. INSTALL FLOOR CARPET COVER CENTER LH 
    Fig 2: Locating Accelerator Pedal Position Sensor Connector And Nuts
    G05136385Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.