2005 Lexus RX 330 FWDFACTORY OEM SERVICE PROCEDURE

Windshield Glass: Replacement

HINT:

The installation is in the reverse order of the removal. However, when there is a special point concerning the installation, it is indicated.

  1. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSY (See  WINDSHIELD WIPER MOTOR ASSY  ) 
    1. Remove the FR wiper arm LH.
    2. Remove the FR wiper arm RH.
    3. Remove the cowl top ventilator louver.
  2. REMOVE FRONT FENDER TO COWL SIDE SEAL RH (See  FRONT BUMPER  or or  ROOF DRIP SIDE FINISH MOULDING LH (MULTI-PANEL MOON ROOF TYPE)  ) 
  3. REMOVE FRONT FENDER TO COWL SIDE SEAL LH (See  FRONT BUMPER  or  ROOF DRIP SIDE FINISH MOULDING LH (MULTI-PANEL MOON ROOF TYPE)  ) 
  4. REMOVE  INNER REAR VIEW MIRROR ASSY  
  5. REMOVE ROOF HEADLINING ASSY (See  REPLACEMENT  ) 
    1. Remove the front door opening trim weatherstrip LH.
    2. Remove the front door opening trim weatherstrip RH.
    3. Remove the front pillar garnish LH.
    4. Remove the front pillar garnish RH.
    5. Remove the map lamp.
    6. Remove the LH visor.
    7. Remove the RH visor.
    8. Remove the 2 assist grip covers.
    9. Remove the assist grip.
    10. Remove the visor holder RH and LH.

      HINT:

      Do not remove the roof headlining completely partially so that the windshield glass can be removed.

  6. W/Rain sensor: REMOVE RAIN SENSOR (See  RAIN SENSOR  ) 
  7. REMOVE WINDSHIELD MOULDING OUTSIDE 
    1. Using a knife, cut off the moulding, as shown in the illustration.
      NOTE: Do not damage the vehicle body with the knife.
    2. Remove the remaining moulding from the vehicle body.

      HINT:

      When removing, make a partial cut, then pull and remove it by hand.

      Fig 1: Cutting Off Moulding
      G03013012Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. W/Deicer:

      Disconnect the connector as shown in the illustration.

      Fig 2: Disconnecting Connector
      G03013013Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  8. REMOVE WINDSHIELD GLASS 
    1. Pass a piano wire between the vehicle body and glass from the interior.
    2. Fig 3: Removing Windshield Glass
      G03013014Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Tie both wire ends to wooden blocks or similar objects.

      HINT:

      Apply protective tape to the outer surface to prevent the surface from being scratched.

      NOTE:
      • When separating the glass, take care not to damage the paint and the interior and exterior ornaments.
      • To prevent the safety pad from being scratched when removing the glass, place a plastic sheet between the piano wire and safety pad.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.