2005 Lexus RX 330 FWDFACTORY OEM SERVICE PROCEDURE

Inspection Procedure

  1. CHECK MANUAL UP/DOWN FUNCTION (DRIVER SIDE) 
    1. Check that the power window manual UP/DOWN function operates normally.
    1. NG: OTHER PROBLEM (See  MANUAL UP/DOWN FUNCTION DOES NOT OPERATE ON DRIVER SIDE   ) 
    2. OK: Go to next step. 
  2. CHECK LAMP OF POWER WINDOW MASTER SWITCH (DRIVER SIDE SWITCH) 
    1. Turn the ignition switch ON.
    2. Operate the driver side switch of the master switch.
    3. Fig 1: Operating Driver Side Switch Of Master Switch
      G03009645Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Check the blinking pattern of the AUTO lamp as shown in Fig 2 .
      1. If pattern (1) is displayed, proceed to A.
      2. If pattern (2) or (3) is displayed, proceed to B.
      3. If the normal pattern is displayed, proceed to C.
      4. Fig 2: Blinking Pattern Of AUTO Lamp
        G03009646Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. B: Go to step   4 . 
    2. C: REPLACE POWER WINDOW REGULATOR MASTER SWITCH ASSY 
    3. A: GO TO NEXT STEP. 
  3. RESET POWER WINDOW REGULATOR MOTOR (DRIVER SIDE) (Refer to pre-check, step   16 ) 
    1. NG: Go to step 4. 
    2. OK: END 
  4. CHECK WIRE HARNESS (POWER WINDOW MASTER SWITCH ASSY - POWER WINDOW REGULATOR MOTOR ASSY AND BODY GROUND) 
    1. Disconnect the P22 master switch connector.
    2. Disconnect the P23 power window motor connector.
    3. Check the resistance of the wire harness side connectors.

      Standard: 

      Fig 3: Power Window Master Switch Assy - Power Window Regulator Motor Assy And Body Ground Table
      G03009647Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.