Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Lexus LX 470FACTORY OEM SERVICE PROCEDURE
Camshaft Position Sensor: Installation
- INSTALL CAMSHAFT POSITION SENSOR
Install the camshaft position sensor with the bolt and stud bolt
Torque: 7.5 N.m (80 kgf.cm, 66 in.lbf)
- INSTALL LH NO. 3 TIMING BELT COVER
(See INSTALLATION )
- CONNECT RADIATOR HOSE
- INSTALL V-BANK COVER
- FILL ENGINE COOLANT (See REPLACEMENT )
- CHECK ENGINE COOLANT FOR LEAKS
- CHECK IGNITION TIMING (See IGNITION TIMING )
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.