2005 Lexus LX 470FACTORY OEM SERVICE PROCEDURE

Charging Systems: Charging: Generator: Removal

  1. DRAIN ENGINE COOLANT (See  REPLACEMENT  ) 
  2. REMOVE GENERATOR DRIVE BELT 

    Loosen the belt by turning the belt tensioner counterclockwise, and remove the drive belt.

    HINT:

    The pulley bolt for the belt tensioner has a left-hand thread.

    Fig 1: Removing Generator Drive Belt
    G02985066Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. REMOVE ENGINE UNDER COVER NO. 1 
  4. REMOVE RADIATOR ASSEMBLY (See  REMOVAL  ) 
  5. REMOVE PS VANE PUMP (See  REMOVAL  ) 
  6. REMOVE GENERATOR 
    1. Disconnect the generator connector.
    2. Remove the rubber cap and nut, and disconnect the generator wire.
    3. Disconnect the generator wire clamp from the cord clip on the generator.
    4. Remove the bolt, 2 nuts and generator.
    Fig 2: Removing Generator
    G02985067Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.