Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Lexus LS 430FACTORY OEM SERVICE PROCEDURE
Supplemental Restraint System: Preparation
SST
Recommended Tools
Torx is a registered trademark of Textron Inc.
Equipment
EQUIPMENT
| Torque wrench | |
| Bolt Length: 35.0 mm (1.378 in.) Pitch: 1.0 mm (0.039 in.) Diameter: 6.0 mm (0.236 in.) | Airbag disposal |
| Tire Width: 185 mm (7.28 in.) Inner diameter: 360 mm (14.17 in.) | Airbag disposal |
| Tire with disc wheel Width: 185 mm (7.28 in.) Inner diameter: 360 mm (14.17 in.) | Airbag disposal |
| Plastic bag | Airbag disposal |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.