Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Lexus IS 300 Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Body & Frame: Windows: Windshield: Installation
- CLEAN AND SHAPE CONTACT SURFACE OF BODY
- Using a knife, cut away any rough areas on the body.
HINT:
Leave as much of the adhesive on the body as possible.
- Clean the cutting surface of the adhesive with a piece of shop rag soaked with cleaner.
HINT:
Even if all the adhesive has been removed with knife, clean the body with the shop rag.
- Using a knife, cut away any rough areas on the body.
- CLEAN REMOVED GLASS
- Remove the damaged No. 2 stoppers and dams.
- Using a scraper, remove the adhesive sticking to the glass.
- Clean the glass with cleaner.
NOTE:- Be careful not to damage the glass.
- Do not touch the glass face after cleaning it.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
