2005 Lexus GX 470FACTORY OEM SERVICE PROCEDURE

Problem Symptoms Table

Use table below to help you find the cause of the problem. The numbers indicate the priority of the likely cause of the problem. Check each part in order.

If necessary, replace these parts.

PROBLEM SYMPTOMS TABLE - TRANSFER CASE SYSTEM

Symptom Suspect Area
Noise
  1. Oil (Level low)
  2. Oil (Wrong)
  3. Transfer faulty
Oil leakage
  1. Oil (Level too high)
  2. Gasket (Damaged)
  3. Oil seal (Worn or damaged)
  4. O-ring (Worn or damaged)
Shift from 4WD (H4) to 4WD (L4) impossible
  1. Four wheel drive control switch
  2. Wire harness
  3. Four wheel drive control ECU
Shift from 4WD (L4) to 4WD (H4) impossible
  1. Four wheel drive control switch
  2. Wire harness
  3. Four wheel drive control ECU
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.