Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Lexus GX 470FACTORY OEM SERVICE PROCEDURE
Camshaft Position Sensor (2UZ-FE): Replacement
- DRAIN ENGINE COOLANT (SEE REPLACEMENT )
- REMOVE FAN AND GENERATOR V BELT (SEE REPLACEMENT )
- REMOVE OIL COOLER PIPE (SEE REPLACEMENT )
- REMOVE TIMING BELT COVER SUB-ASSY NO. 3 LH (SEE REPLACEMENT )
- REMOVE CAMSHAFT POSITION SENSOR
- Disconnect the camshaft position sensor connector.
- Remove the bolt, stud bolt and camshaft position sensor.
- INSTALL CAMSHAFT POSITION SENSOR
- Install the camshaft position sensor with the bolt and stud bolt.
Torque: 7.5 N.m (80 kgf.cm, 66 in.lbf)
- Install the camshaft position sensor with the bolt and stud bolt.
- INSTALL TIMING BELT COVER SUB-ASSY NO. 3 LH (SEE REPLACEMENT )
- INSTALL OIL COOLER PIPE (SEE REPLACEMENT )
- INSTALL FAN AND GENERATOR V BELT (SEE REPLACEMENT )
- REFILL ENGINE COOLANT (SEE COOLANT (2UZ-FE) )
- CHECK FOR ENGINE COOLANT LEAKS (SEE ON-VEHICLE INSPECTION )
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
