2005 Lexus GX 470FACTORY OEM SERVICE PROCEDURE

Ignition Switch/Steering Lock: Replacement

HINT:

The installation is in the reverse order of the removal. However, when there is a special point concerning the installation, it is indicated.

  1. REMOVE STEERING COLUMN COVER LWR (SEE  OVERHAUL  ) 
  2. REMOVE STEERING COLUMN COVER UPR (SEE  OVERHAUL  ) 
  3. REMOVE IGNITION OR STARTER SWITCH ASSY 
    1. Disconnect the ignition switch connector and unlock warning switch connector.
    2. Remove the clamp.
    3. Remove the 2 screws and ignition switch assy.
      Fig 1: Removing Ignition Or Starter Switch Assy
      G02963192Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.