2005 Lexus GS 430FACTORY OEM SERVICE PROCEDURE

Body & Frame: Windows: Windshield: Installation

  1. CLEAN AND SHAPE CONTACT SURFACE OF BODY 
    1. Using a knife, cut away any rough areas on the body.

      HINT:

      Leave as much of the adhesive on the body as possible.

    2. Clean the cutting surface of the adhesive with a piece of shop rag saturated in cleaner.

      HINT:

      Even if all the adhesive has been removed, clean the body.

      Fig 1: Cleaning & Shaping Contact Surface Of Body
      G02940081Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL NEW STOPPERS 
    1. Remove the damaged stoppers.
    2. Cut off the old adhesive around the stoppers installation area.
      NOTE: Be careful not to damage the body.
    3. Clean the installation area.
    4. Attach new stoppers to the glass with the ceramic notch on the glass aligned with the stoppers, as shown in Fig 2.
      Fig 2: Attaching New Stoppers To Glass
      G02940082Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. INSTALL NEW RETAINERS 
    1. Remove the damaged retainers.
    2. Cut off the old adhesive around the retainers installation area.
      NOTE: Be careful not to damage the body.
    3. Clean the installation area.
    4. Attach new retainers to the glass with the ceramic notch on the glass aligned with the retainers, as shown in Fig 3.
      Fig 3: Attaching New Retainers To Glass
      G02940083Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. CLEAN REMOVED GLASS 
    1. Using a scraper, remove the adhesive sticking to the glass.
    2. Clean the glass with cleaner.
      NOTE:
      • Be careful not to damage the glass.
      • Do not touch the glass after cleaning it.
      Fig 4: Cleaning Removed Glass
      G02940084Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  5. INSTALL NEW DAMS 

    Install new dams with double-stick tape as shown in Fig 5.

    A: 6.1 mm (0.240 in.) 

    NOTE: Do not touch the glass surface after cleaning it.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.