Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Lexus ES 330FACTORY OEM SERVICE PROCEDURE
Torque Specifications
STEERING COLUMN TORQUE SPECIFICATIONS
| Part tightened | N.m | kgf.cm | ft..lbf |
|---|---|---|---|
| Steering column assembly set bolt and nut | 21 | 214 | 15 |
| Steering Intermediate shaft sub-assy at Steering sliding yoke sub-assy | 35 | 360 | 26 |
| Steering Intermediate shaft at Steering gear assy | 35 | 360 | 26 |
| Steering wheel set nut | 50 | 510 | 37 |
| Steering wheel pad set screw (Torx screw) | 8.8 | 90 | 78 in..lbf |
| Main shaft assy at Steering sliding yoke sub-assy | 35 | 360 | 26 |
| Tie rod end lock nut | 74 | 755 | 55 |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.