Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Lexus ES 330FACTORY OEM SERVICE PROCEDURE
Service Data
Front Suspension Service Data
| Cold tire inflation pressure | Tire size: P215/60R16 94V | Front, Rear | 200 kPa (2.0 kgf/cm2 29 psi) | ||||||||
| Front wheel alignment | Vehicle height | Front: A(1) - B (2) | 120 mm (4.72 in.) | ||||||||
| Rear: D(3) - C(4) | 52 mm (2.05 in.) | ||||||||||
| Toe-in (total) | 0° ± 12' (0° ± 0.2°, 0 ± 2 mm, 0 ± 0.08 in.) | ||||||||||
| Rack end length difference | 1.5 mm (0.059 in.) or less | ||||||||||
| Wheel angle | Inside wheel | 36°39' ± 2° (36.65° ± 2°) | |||||||||
| Outside wheel: Reference | 32°11' (32.18°) | ||||||||||
| Camber | -0°43' ± 45' (-0.72° ± 0.75°) | ||||||||||
| Right-left error | 45' (0.75°) or less | ||||||||||
| Caster | 2°46' ± 45' (2.77° ± 0.75°) | ||||||||||
| Right-left error | 45' (0.75°) or less | ||||||||||
| Steering axis inclination | 11°27' ± 45' (11.45° ± 0.75°) | ||||||||||
| Right-left error | 45' (0.75°) or less | ||||||||||
| Front suspension | Lower ball joint turning torque | 0.98 - 3.43 N.m (10 - 35 kgf.cm, 8.7 - 30 in.lbf) | |||||||||
| Stabilizer bar link ball joint turning torque | 0.05 - 1.96 N.m (0.5 - 20 kgf.cm, 0.4 - 17.4 in.lbf) | ||||||||||
|
|||||||||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
