Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Lexus ES 330FACTORY OEM SERVICE PROCEDURE
Torque Specifications
COOLING TORQUE SPECIFICATIONS
| Part Tightened | N.m | kgf.cm | ft..lbf |
|---|---|---|---|
| Cylinder block drain cock plug at Cylinder block drain cock | 13 | 130 | 9.0 |
| Water pump assy at Cylinder block | 8.0 | 82 | 71 in..lbf |
| Timing belt Idler sub-assy No. 1 at Cylinder block | 34 | 347 | 25 |
| Water inlet at Water inlet housing | 8.0 | 82 | 71 in..lbf |
| Water inlet pipe at Cylinder head | 20 | 199 | 14 |
| Fan shroud sub-assy at Radiator assy | 5.0 | 51 | 44 in..lbf |
| Radiator support upper at body | 14 | 142 | 10 |
| Hood lock assy at Radiator support upper | 8.0 | 82 | 71 in..lbf |
| ATM oil cooler at Radiator tank lower | 8.3 | 85 | 74 in..lbf |
| Inlet No. 2 at ATM oil cooler | 15 | 150 | 11 |
| Inlet No. 1 at ATM oil cooler | 15 | 150 | 11 |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
