2005 Lexus ES 330FACTORY OEM SERVICE PROCEDURE

Cruise Control Main Switch: Replacement

WARNING: This page is about a different car, the 2005 Toyota Sienna. However, it is still accessible from the selected car via links, so may be relevant.
  1. DISCONNECT BATTERY NEGATIVE TERMINAL (See  SUPPLEMENTAL RESTRAINT SYSTEM  ) 
  2. REMOVE STEERING WHEEL COVER LOWER NO.2 
  3. REMOVE STEERING WHEEL COVER LOWER NO.3 
  4. REMOVE HORN BUTTON ASSY (See  REPLACEMENT  ) 
  5. REMOVE CRUISE CONTROL MAIN SWITCH 
    1. Disconnect the connectors.
    2. Remove the 2 screws and cruise control main switch.
    Fig 1: Removing Cruise Control Main Switch (1 Of 2)
    G02607520Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.