2005 Lexus ES 330FACTORY OEM SERVICE PROCEDURE

Section 132 (Power Window Control System (W/Jam Protection) - Diagnostics): Pre-Check

WARNING: This page is about a different car, the 2005 Toyota Sienna. However, it is still accessible from the selected car via links, so may be relevant.
  1. USING HAND-HELD TESTER 
    1. Connect the hand-held tester to the DLC3.
    2. Monitor the ECU data by following the prompts on the tester screen.

    HINT:

    The hand-held tester has a "Snapshot" function which records the monitored data. Refer to the hand-held tester operator's manual for further details.

  2. DATA LIST 

    HINT:

    Using the DATA LIST displayed by the hand-held tester, you can read the values of the switch, sensor, actuator, etc. without parts removal. Reading the DATA LIST as the first step of troubleshooting is one way to shorten the labor time.

    1. Connect the hand-held tester to the DLC3.
    2. Turn the ignition switch ON.
    3. Read the DATA LIST according to the display on the tester.

      Standard (Multiplex network body ECU): 

      Fig 1: Standard (Multiplex Network Body ECU) Specification Table
      G02630530Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. ACTIVE TEST 

    HINT:

    Performing the ACTIVE TEST using the hand-held tester allows you to operate the relay, VSV, actuator, etc. without parts removal. Performing the ACTIVE TEST as the first step of troubleshooting is one way to shorten the labor time.

    It is possible to display the DATA LIST during the ACTIVE TEST.

    1. Connect the hand-held tester to the DLC3.
    2. Turn the ignition switch ON.
    3. Perform the ACTIVE TEST according to the display on the tester.

      Standard (Multiplex network body ECU): 

      DIAGNOSTIC PROCEDURE

      Item Test Detail Diagnostic Note
      IG OFF P/W Ignition switch OFF power window control permission output ON/OFF -
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.