Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Lexus ES 330FACTORY OEM SERVICE PROCEDURE
Inspection Procedure
WARNING: This page is about a different car, the 2005 Toyota Sienna. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK MANUAL UP/DOWN FUNCTION (DRIVER SIDE)
- Check that the door glass can be operated manually.
- NG: OTHER PROBLEM (See MANUAL UP/DOWN FUNCTION DOES NOT OPERATE ON DRIVER SIDE )
- OK: GO TO NEXT STEP
- CHECK ILLUMINATION OF POWER WINDOW MASTER SWITCH
- Turn the ignition switch ON.
- Operate the AUTO (drive side) switch of the master switch.
- Check the blinking pattern of the AUTO light as shown in Fig 2
.
- If pattern (1) is displayed, proceed to A.
- If pattern (2) or (3) is displayed, proceed to B.
- If the normal pattern is displayed, proceed to C.
- B: Go to step 4
- C: REPLACE POWER WINDOW REGULATOR MASTER SWITCH ASSY
- A: GO TO NEXT STEP
- RESET POWER WINDOW REGULATOR MOTOR (DRIVER SIDE) (See
RESET
)
- OK: END
- NG: GO TO NEXT STEP
- CHECK WIRE HARNESS (MASTER SWITCH - MOTOR) (MASTER SWITCH - BODY GROUND)
- Disconnect the D9 master switch connector.
- Disconnect the P40 motor connector (driver side).
- Check the resistance between the wire harness side connectors.
Standard:
TERMINAL SPECIFIED CONDITIONTerminal No. Specified Condition D9-3 (VC) - P40-4 (SSRB) Below 1 Ω D9-14 (PLS1) - P40-5 (PLS) D9-17 (PLS2) - P40-3 (PLS2) D9-2 (SGND) - P40-6 (E) - Check the resistance between the D9 master switch connector and body ground.
Standard:
TERMINAL SPECIFIED CONDITIONTerminal No. Specified Condition D9-3 (VC) - Body ground 10 KΩ or higher D9-14 (PLS1) - Body ground D9-17 (PLS2) - Body ground D9-2 (SGND) - Body ground
- NG: REPAIR OR REPLACE HARNESS AND CONNECTOR
- OK: REPLACE POWER WINDOW REGULATOR MOTOR ASSY LH (DRIVER SIDE)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
