Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Lexus ES 330FACTORY OEM SERVICE PROCEDURE
Torque Specification
WARNING: This page is about a different car, the 2005 Toyota Sienna. However, it is still accessible from the selected car via links, so may be relevant.
IGNITION TORQUE SPECIFICATION
| Part Tightened | N.m | kgf.cm | ft.lbf |
|---|---|---|---|
| VVT sensor x Cylinder head sub-assy | 8.0 | 80 | 71 in.lbf |
| VVT sensor x Cylinder head LH | 8.0 | 80 | 71 in.lbf |
| Crankshaft position sensor x Oil pump assy | 8.0 | 80 | 71 in.lbf |
| Spark plug x Cylinder head | 25 | 250 | 18 |
| Ignition coil (with igniter) x Cylinder head cover | 8.0 | 82 | 71 in.lbf |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.