Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Lexus SC 430FACTORY OEM SERVICE PROCEDURE
Technical Service Bulletins
- A/C Compressor
- Accessories & Equipment
- Accessories Control Systems
- Immobilizer And Smart Key Reset (SS002-01)
- TECHSTREAM Ecu Flash Reprogramming Procedure (SS002-07)
- Failure To Initialize Can Interface Module (SS001-05)
- Navigation System Door Replacement (BO011-04)
- Initialization Of Front Seat Position And Seatback Angle (PG005-03)
- Diagnostic Tester Controller Area Network (Can) Interface Module (SS001-03)
- Air Bag, SRS
- Anti-Theft Systems
- Automatic Trans
- Interior Electrical Component Precautions (L-SB-0066-11 REV2)
- Automatic Transmission Replacement Precautions (L-SB-0082-14)
- Torque Converter Bolt Installation (L-SB-0007-11 REV1)
- World Standard Automatic Transmission Fluid (TC008-07)
- Alignment Pin Installation During Transmission/Transaxle Assembly Installation (L-SB-0026-08)
- Automatic Transmission Shipping Bag For Warranty Recovery (TC010-07)
- A650E Transmission Solenoid Identification (TC004-05)
- Auxiliary Emission Control Systems
- Battery Management Systems
- Body Electrical
- Body Interior
- Brakes Control Systems
- Charging Systems
- Cooling System (Mechanical)
- Cruise Control Systems
- Differentials & Drive Axles
- Driveshaft & Universal Joints
- Engine Control Systems
- Entertainment Systems
- Exhaust
- Exterior Body Panels
- Frames, Subframes & Crossmembers
- Gauges & Instrument Panels
- Headlights
- HVAC Control Systems
- Identification
- Ignition Switch/Steering Lock
- Infotainment
- Interior/Exterior Trim
- Lubrication System
- Mechanical
- Mechanical - Hydraulic
- Mirrors
- Paint & Coatings
- Iron Particle Rust Contamination Repair (L-SB-0020-24)
- New Vehicle Washing Schedule For Paint Protection (L-SB-0024-24)
- Prevention And Repair Of Acid Rain Damage (L-SB-0022-24)
- Permanent-Type Protective Wax Coatings (L-SB-0083-08)
- Acid Rain Paint Finish Damage - Prevention & Repair - Crib # 165 (S-CRIB-165)
- Paint Stains Under RAPGARD™ (PA001-03 REV.)
- Iron Particle Rust Contamination Repair (PA001-05)
- Exterior Color And Scratch Resistant And Anti-Acid Paint (PA001-04)
- 2004 Paint Colors (PA003-03)
- Parking Brake System
- Passive Restraints
- Procedures
- Restraints Control Systems
- Seats
- Starter
- Steering Column
- Steering Control Systems
- Suspension Control Systems
- System
- Transmission Control Systems
- Interior Electrical Component Precautions (L-SB-0066-11 REV2)
- TECHSTREAM Ecu Flash Reprogramming Procedure (SS002-07)
- A650E Transmission Solenoid Identification (TC004-05)
- ECM Reset Memory Function (TC002-03)
- Ecu Flash Reprogramming Process (SS001-01)
- Diagnostic Tester Controller Area Network (Can) Interface Module (SS001-03)
- Warning Systems
- Wheel Alignment
- Wheels & Tire System
- Window Motors & Regulators
- Wiper/Washer Systems
- Wiring System (Data Link Connectors, Pwr Dist., Grnd Dist.)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.