2004 Lexus SC 430FACTORY OEM SERVICE PROCEDURE

Electrical Component Locator: Splices

SPLICES LOCATION

Component Location
B2 In body harness, near roof position limit switch No. 3. See Figure.
B3 In body harness, near breakout to telephone computer. See Figure.
B4 In body harness, near breakout to rear woofer. See Figure.
E1 In engine No. 4 harness, near breakout to positive battery cable. See Figure.
E2 In engine wire harness, near breakout to ground EB. See Figure.
E3 In engine wire harness, near breakout to fuel injector No. 5. See Figure.
E4 Near engine control module. See Figure.
E5 Near engine control module. See Figure.
E6 In engine compartment main harness, near center of left fender. See Figure.
I1 In A/C sub No. 2 wire harness, near connector for driver's side air mix control servo motor. See Figure.
I2 At right "A" pillar, near connector IK2. See Figure.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.