2004 Lexus RX 330 FWDFACTORY OEM SERVICE PROCEDURE

Speed Sensor (U151E/U151F): Replacement

  1. REMOVE BATTERY 
  2. REMOVE AIR CLEANER ASSY 
  3. REMOVE AIR CLEANER HOSE NO. 1 
  4. REMOVE AIR CLEANER INLET NO. 2 
  5. REMOVE AIR CLEANER BRACKET 
  6. REMOVE AIR CLEANER INLET NO. 1 
  7. REMOVE SPEED SENSOR (NT SENSOR) 
    1. Disconnect the speed sensor connector.
    2. Remove the bolt and speed sensor.
      Fig 1: Removing Speed Sensor (NT Sensor)
      G00888366Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  8. REMOVE SPEED SENSOR (NC SENSOR) 
    1. Disconnect the speed sensor connector.
    2. Remove the bolt and speed sensor.
      Fig 2: Removing Speed Sensor (NC Sensor)
      G00888367Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  9. INSTALL SPEED SENSOR (NC SENSOR) 
    1. Coat the O-ring with ATF.
    2. Install the speed sensor with the bolt.

      Torque: 11 N.m (115 kgf.cm, 8 ft.lbf) 

      HINT:

      Make sure of the sensor manufacturer's name.

    3. Connect the speed sensor connector.
      Fig 3: Installing Speed Sensor (NC Sensor)
      G00888368Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  10. INSTALL SPEED SENSOR (NT SENSOR) 
    1. Coat the O-ring with ATF.
    2. Install the speed sensor with the bolt.

      Torque: 11 N.m (115 kgf.cm, 8 ft.lbf) 

      HINT:

      Make sure of the sensor manufacturer's name.

    3. Connect the speed sensor connector.
      Fig 4: Installing Speed Sensor (NT Sensor
      G00888369Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  11. INSTALL AIR CLEANER INLET NO. 1 
  12. INSTALL AIR CLEANER BRACKET 
  13. INSTALL AIR CLEANER INLET NO. 2 
  14. INSTALL AIR CLEANER HOSE NO. 1 
  15. INSTALL AIR CLEANER ASSY 
  16. INSTALL BATTERY 
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.