Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Lexus RX 330 FWDFACTORY OEM SERVICE PROCEDURE
Fuel System (3MZ-FE): Inspection
- INSPECT FUEL INJECTOR ASSY
- Inspect injector resistance
- Using an ohmmeter, measure the resistance between the terminals.
Resistance: 13.4 to 14.2 Ω at 20°C (68°F)
If the resistance is not as specified, replace the injector.
- Using an ohmmeter, measure the resistance between the terminals.
- Inspect injector operationCAUTION:
- This test involves high-pressure fuel and electricity.
- Take every precaution regarding safe handling of both the fuel and the electricity.
- Perform this test in a safe area, and avoid any sparks or flame.
- Do not smoke.
- Pull out the connector from a new fuel tube.
HINT:
Part No. 23801 - 20180
- Connect SST and the fuel tube connector to the fuel pipe.
SST 09268-41047 (95336-08070)
CAUTION: After taking the precaution, connect the fuel tube connector (quick type).
- Inspect injector resistance
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
