Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Lexus RX 330 AWDFACTORY OEM SERVICE PROCEDURE
Circuit Protection Devices
CIRCUIT PROTECTION DEVICES LOCATION
| Component | Location |
|---|---|
| Engine Room R/B | On left side of engine compartment. See Figure. |
| Fusible Link Block | In engine room R/B. See Figure. |
| Instrument Panel J/B | Left side of dash. See Figure. |
| Overhead J/B | Front center of roof. See Figure. |
| J/B No. 2 | In engine room R/B. See Figure. |
| J/B No. 3 | Left side of dash. See Figure. |
| J/B No. 4 | Right side of dash. See Figure. |
| R/B No. 1 | Left side of dash. See Figure. |
| R/B No. 3 | Right side of engine compartment. See Figure. |
| Rear J/B | Left rear side of cargo area. See Figure. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.