2004 Lexus RX 330 AWDFACTORY OEM SERVICE PROCEDURE

Torque Specification

Torque Specification

Part Tightened N.m kgf.cm ft.lbf
Pneumatic cylinder assy x Air tube 17 175 13
Height control compressor assy x Height control dryer assy 6.4 65 57 in.lbf
Height control compressor x Rear height control compressor bracket 5.9 60 52 in.lbf
Height control compressor bracket x Rear height control compressor bracket 19 194 14
Pneumatic w/tube tank assy x Body 29 296 21
Height control sensor sub-assy front x Body 7.8 80 69 in.lbf
Height control sensor sub-assy front x Lower arm assy 5.4 55 48 in.lbf
Front disc wheel hub nut 103 1,050 76
Height control sensor sub-assy rear x Rear suspension member sub-assy 7.8 80 69 in.lbf
Height control sensor sub-assy rear x Rear suspension arm assy No.2 5.4 55 48 in.lbf
Height control valve sub-assy No.1 x Body 5.4 55 48 in.lbf
Height control valve sub-assy No.2 x Body 5.4 55 48 in.lbf
Suspension control ECU x Airconditioner amplifier assy 7.8 80 69 in.lbf
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.