2004 Lexus LX 470FACTORY OEM SERVICE PROCEDURE

Circuit Opening Relay: Inspection

  1. REMOVE RELAY BOX COVER 
  2. REMOVE CIRCUIT OPENING RELAY (Marking: C/OPN) 
    Fig 1: Identifying Circuit Opening Relay
    G00920353Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. INSPECT CIRCUIT OPENING RELAY CONTINUITY 
    1. Using an ohmmeter, check that there is a continuity between terminal 1 and 2.

      If there is no continuity, replace the relay.

    2. Check that there is no continuity between terminals 3 and 5.

      If there is a continuity, replace the relay.

    Fig 2: Checking Circuit Opening Relay Continuity
    G00920354Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. INSPECT CIRCUIT OPENING RELAY OPERATION 
    1. Apply the battery positive voltage across terminal 1 and 2.
    2. Using an ohmmeter, check that there is a continuity between terminal 3 and 5.

      If there is no continuity, replace the relay.

    Fig 3: Checking Circuit Opening Relay Operation
    G00920355Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  5. REINSTALL CIRCUIT OPENING RELAY 
  6. REINSTALL RELAY BOX COVER 
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.