Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Lexus LS 430FACTORY OEM SERVICE PROCEDURE
Service Data
Identifying Rear Suspension Service Data
| Rear wheel alignment | Toe-in (total) | 0°18' ± 12' (0.3° ± 0.2°, 3 ± 2 mm, 0.12 ± 0.08 in.) | |
| No.2 lower suspension arm length difference | |||
| 2WD | 1.5 mm (0.06 in.) or less | ||
| 4WD | 1.0 mm (0.04 in.) or less | ||
| Camber | |||
| Air suspension: | -1°35' ±45' (-1.58° ± 0.75°) | ||
| Coil suspension: | -1°15' ± 45' (-1.25° ± 0.75°) | ||
| Right-left error | 45' (0.75°) or less | ||
| Rear Suspension | Stabilizer link ball joint turning torque | 0.05 to 0.98 N.m (0.5 to 10 kgf.cm, 0.4 to 9 in..lbf) or less | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
