2004 Lexus LS 430FACTORY OEM SERVICE PROCEDURE

Starter Relay Test: 2004

Measure resistance between specified terminals. For resistance specifications, see STARTER RELAY CONDITIONSΒ . To identify starter relay terminal locations, see Figure

STARTER RELAY CONDITIONS

Ohmmeter Connection Resistance
Terminals No. 3 & 5 With No Battery Voltage Applied Through Terminals No. 1 & 2 10,000 Ohms Or More
Terminal No. 3 & 5 With Battery Voltage Applied Through Terminals No. 1 & 2 Less Than One Ohm
Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.