Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Lexus LS 430FACTORY OEM SERVICE PROCEDURE
Inspection Procedure
- CHECK POWER WINDOW LOCK SWITCH
- Turn the window lock switch OFF. Then operate the remote UP/DOWN function of the power window regulator master switch assy, passenger door and rear door windows. Check if function operates normally.
OK: Remote UP/DOWN function operates normally.
NG: Go to step 2
OK: Go to next step.
- CHECK MANUAL UP/DOWN FUNCTION
- Check that the passenger side power window manual UP/DOWN function operates normally.
NG: OTHER PROBLEM (See PROBLEM SYMPTOMS TABLE )
OK: Go to next step.
- CHECK WIRE HARNESS
- Disconnect the D25, F17, R13 and R14 ECU connector.
- Disconnect the DG and DI J/B connectors.
- Disconnect the PE and PI J/B connectors.
- Measure the resistance of the wire harness side connectors.
Standard:
Driver side J/B, passenger side J/B
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
