Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSLEXUS2004IS 300 BASE, AUTOMATICREPAIR AND DIAGNOSISENGINE PERFORMANCEIGNITION SYSTEMIGNITIONCRANKSHAFT POSITION SENSORREMOVAL
2004 Lexus IS 300 Base, Automatic
Crankshaft Position Sensor: Removal
2004 Lexus IS 300 Base, AutomaticSECTION Removal
- REMOVE GENERATOR (See REMOVAL & INSTALLATION )
- DISCONNECT CRANKSHAFT POSITION SENSOR CONNECTOR
- Disconnect the sensor connector.
- Remove the bolt holding the connector bracket to the water pump.
- REMOVE CRANKSHAFT POSITION SENSOR
- Remove the bolt and sensor.
- Torque: 9.0 N.m (90 kgf.cm, 80 in..lbf)
- Remove the connector bracket from the connector.
- Remove the bolt and sensor.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.