2004 Lexus GX 470FACTORY OEM SERVICE PROCEDURE

Steering Column System: Steering: Repair

  1. STEERING OFF CENTER REPAIR PROCEDURE 
    1. Inspect steering wheel off center.
      1. Apply masking tape on the top center of the steering wheel and steering column upper cover.
      2. Drive the vehicle in a straight line for 100 meters at a constant speed of 35 mph (56 km/h), and hold the steering wheel to maintain the course.
        Fig 1: Identifying Masking Tape On Steering Wheel
        G00920120Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      3. Draw a line on the masking tape as shown in the illustration.
        Fig 2: Identifying Line On Masking Tape
        G00920121Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      4. Turn the steering wheel to its straight position.
        Fig 3: Positioning Straight Steering Wheel
        G00920122Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

        HINT:

        Refer to the upper surface of the steering wheel, steering spoke and SRS airbag line for the straight position. See AIR BAG RESTRAINT SYSTEMS .

      5. Draw a new line on the masking tape or the steering wheel as shown in the illustration.
      6. Measure the distance between the 2 lines on the masking tape of the steering wheel.
      7. Convert the measured distance to steering angle.

      Measured distance 1 mm (0.04 in.) = Steering angle approximately 1 deg. 

      HINT:

      Make a note of the steering angle.

    2. Adjust steering angle.
      1. Draw a line on the RH and LH tie rod and on the RH and LH rack end which can easily be seen.
      2. Using a paper gauge, measure the distance from RH and LH tie rod ends to the rack end screws.

        HINT:

        • Measure the RH side and LH side.
        • Make a note of the measured values.
        Fig 4: Identifying Marking On Tie Rod
        G00920123Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      3. Remove the RH and LH boot clips from the rack boots.
      4. Loosen the RH and LH lock nuts.
      5. Turn the RH and LH rack end by the same amount (but in different directions) according to the steering angle.

        1 turn 360 deg. of rack end (1.5 mm (0.059 in.) horizontal movement) - 12 deg. of steering angle. 

        Fig 5: Identifying Rack Boots Clips & Lock Nut
        G00920124Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      6. Tighten the RH and LH lock nuts.
        1. Torque: 74 N.m (755 kgf.cm, 55 ft.lbf) 
        NOTE: Make sure that the difference in length between RH and LH tie rod ends and rack end screws are within 1.5 mm (0.059 in.). 
      7. Install the RH and LH boot clips.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.