SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSLEXUS2004GX 470REPAIR AND DIAGNOSISRESTRAINTSRESTRAINTS CONTROL SYSTEMSSEAT BELTDISPOSAL
2004 Lexus GX 470

Seat Belt: Disposal

2004 Lexus GX 470SECTION Disposal

HINT:

When scrapping vehicles equipped with a seat belt pretensioner or disposing of a front seat outer belt (with seat belt pretensioner), always first activate the seat belt pretensioner in accordance with the procedures described below. If any abnormality occurs in activation of the seat belt pretensioner, contact the SERVICE DEPT. of the TOYOTA MOTOR SALES, U.S.A., INC. When disposing of a front seat outer belt assy (with seat belt pretensioner) that was activated in a collision, follow the same procedures listed in step 1-(e) in "DISPOSAL".

CAUTION:
  • Never dispose of a front seat outer belt assy with an inactivated pretensioner.
  • The seat belt pretensioner produces a sizeable exploding sound when it activates, so perform the operation outdoors so that it will not be a nuisance to nearby residents.
  • When activating a front seat outer belt (with seat belt pretensioner), control operation at least 10 m (33 ft) away from the front seat outer belt.
  • Use gloves and safety glasses when handling a front seat belt with an activated pretensioner. Always wash your hands with water after completing activation.
  • Do not apply water, etc. to a front seat outer belt with an activated pretensioner.
  • When activating the seat belt pretensioner, always use the specified SST (SRS airbag deployment tool). Perform operation in a place away from electrical interference.

SST 09082-00700

Fig 1: Identifying SST
G03476373Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  1. DISPOSE OF FRONT SEAT OUTER BELT ASSY RH (WHEN INSTALLED IN VEHICLE) 

    HINT:

    Check that the battery positive voltage is above 12 V.

    Fig 2: Checking Battery Positive Voltage
    G03476374Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Check the functioning of SST.
      CAUTION: When activating the seat belt pretensioner, always use the specified SST.

      SST 09082-00700,09082-00770

      Fig 3: Checking Functioning Of SST
      G03476375Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Connect the SST red clip to the battery positive (+) terminal and the black clip to the battery negative (-) terminal.

        HINT:

        Do not connect the yellow connector which will be connected to the seat belt pretensioner.

        Fig 4: Connecting SST Red Clip To Battery Positive Terminal And Black Clip To The Battery Negative Terminal
        G03476376Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      2. Press the SST activation switch, and check that the LED of the SST activation switch lights up.
      CAUTION: If the LED lights up when the activation switch is not pressed, the SST may have a malfunction, so do not use the SST.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.