Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Lexus GX 470FACTORY OEM SERVICE PROCEDURE
Speed Sensor Front LH: Replacement
HINT:
Replacement of RH side is same as that of LH side.
- REMOVE FRONT WHEEL
- REMOVE SPEED SENSOR FRONT LH
- Disconnect the speed sensor connector.
- Using a hexagon wrench (5 mm), remove the bolt and front speed sensor from the steering knuckle.
NOTE:- Do not stick a foreign matter on the sensor tip.
- Do not let the foreign matter into the sensor installation hole.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
