2004 Lexus GS 430FACTORY OEM SERVICE PROCEDURE

Front Wheel Alignment: Adjustment

WARNING: This page is about a different car, the 2004 Lexus GX 470. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT TIRE (See  INSPECTION  ) 
  2. MEASURE VEHICLE HEIGHT 

    Vehicle height: 

    Fig 1: Identifying Vehicle Height Specification Chart
    G00918704Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

    Measuring points: 

    1. A: Ground clearance of front wheel center 
    2. B: Ground clearance of lower suspension arm No.2 set bolt center 
    3. C: Ground clearance of rear wheel center 
    4. D: Ground clearance of strut rod set bolt center 
    NOTE: Before inspecting the wheel alignment, adjust the vehicle height to the specified value.
    If the vehicle height is not the specified value, try to adjust it by pushing down on or lifting the body.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.