2004 Lexus GS 430FACTORY OEM SERVICE PROCEDURE

Without Hand-Held Sensor

  1. Turn ignition switch off.
  2. Using special tool (09843-18020), jumper between terminals Ts and E1 of (DLC1). See Figure.
  3. Start engine and check that ABS warning light flashes. If ABS warning light does not flash, inspect ABS warning light circuit and Ts circuit. See TEST B: ABS WARNING LIGHT CIRCUIT  and TEST H: TS TERMINAL CIRCUIT  .
  4. If ABS warning light flashes, leave vehicle condition and brake pedal in free condition for one second or more. Depress brake pedal for one second or more with at least 22 ft.lbs. (98 N.m.) of force.
  5. Leaving vehicle in stationary condition, depress brake pedal quickly with 221 ft.lbs. (980 N.m.) of force. At this time the ABS warning light comes on for 3 seconds.
  6. Drive vehicle straight forward at speed of 28 mph or more for several seconds. Check that ABS warning light turns off.
  7. Stop the vehicle. Using special tool (09843-18020), jumper between terminals Tc and E1 of (DLC1). See Figure.
  8. Read the number of flashes of ABS warning light. If any DTCs are retrieved, perform appropriate test. See DIAGNOSTIC TROUBLE CODE DEFINITIONS .
  9. If all speed sensors are normal, a normal code is output. See Figure.
  10. If 2 or more malfunctions are indicated at the same time, the lowest numbered code will be displayed first.
  11. Turn ignition switch off and remove special tools from (DLC1).
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.