Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Lexus ES 330FACTORY OEM SERVICE PROCEDURE
Service Data
WARNING: This page is about a different car, the 2005 Toyota Sienna. However, it is still accessible from the selected car via links, so may be relevant.
Lubrication Service Data
| Oil pressure | at idle speed | 29 kPa (0.3 kgf/cm2 , 4.3 psi) or more |
| at 3,000 rpm | 294 to 539 kPa (3.0 to 5.5 kgf.cm2 , 43 to 78 psi) or more | |
| Oil pump assy | ||
| Tip clearance | Standard | 0.11 to 0.24 mm (0.0043 to 0.0094 in.) |
| Maximum | 0.35 mm (0.0138 in.) | |
| Body clearance | Standard | 0.125 to 0.162 mm (0.0050 to 0.0064 in.) |
| Maximum | 0.30 mm (0.0118 in.) | |
| Side clearance | Standard | 0.03 to 0.09 mm (0.0012 to 0.0035 in.) |
| Maximum | 0.15 mm (0.0059 in.) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.