2004 Lexus ES 330FACTORY OEM SERVICE PROCEDURE

Generator ASSY: Replacement

WARNING: This page is about a different car, the 2004 Toyota Sienna. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE GENERATOR ASSY 
    1. Remove the wire harness clamp.
    2. Disconnect the generator connector.
    3. Open the terminal cap and remove the nut and the generator wire.
      Fig 1: Disconnecting Generator Connector
      G02608882Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Loosen bolts A and B.
    5. Loosen bolt C to lessen the tension of the V belt No. 1.
      Fig 2: Loosening Bolt C
      G02608883Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    6. Remove bolts A, B and the generator.
    Fig 3: Removing Bolts A, B And Generator
    G02608884Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL GENERATOR ASSY 
    1. Temporarily install generator with bolts A and B.
      Fig 4: Installing Generator With Bolts A & B
      G02608885Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Adjust the V belt No. 1 tension by tightening bolt C. (See INSPECTION )
      Fig 5: Adjusting V Belt No. 1 Tension
      G02608886Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Tighten bolts A and B.

      Torque: 

      58 N.m (592 kgf.cm, 43 ft.lbf) for bolt A 

      18 N.m (184 kgf.cm, 13 ft.lbf) for bolt B 

    4. Install the generator wire with the nut.

      Torque: 9.8 N.m (100 kgf.cm, 7 ft.lbf) 

    5. Connect the generator connector.
    6. Install the wire harness clamp.
  3. INSPECT DRIVE BELT (See  INSPECTION  ) 
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.