Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Lexus ES 330FACTORY OEM SERVICE PROCEDURE
Section 145 (Knock Sensor): Replacement
WARNING: This page is about a different car, the 2004 Toyota Sienna. However, it is still accessible from the selected car via links, so may be relevant.
- DISCHARGE FUEL SYSTEM PRESSURE, see PRECAUTION .
- DRAIN ENGINE COOLANT, see REPLACEMENT .
- REMOVE FRONT WIPER ARM HEAD CAP, see WINDSHIELD WIPER MOTOR ASSY .
- REMOVE FR WIPER ARM LH, see WINDSHIELD WIPER MOTOR ASSY .
- REMOVE FR WIPER ARM RH, see WINDSHIELD WIPER MOTOR ASSY .
- REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY, see WINDSHIELD WIPER MOTOR ASSY .
- REMOVE WINDSHIELD WIPER MOTOR ASSEMBLY, see WINDSHIELD WIPER MOTOR ASSY .
- REMOVE COWL TOP TO COWL BRACE INNER NO. 1, see REPLACEMENT .
- REMOVE COWL TOP PANEL SUB-ASSEMBLY OUTER FRONT, see REPLACEMENT .
- REMOVE V-BANK COVER SUB-ASSEMBLY, see REPLACEMENT .
- REMOVE AIR CLEANER CAP SUB-ASSEMBLY, see REPLACEMENT .
- REMOVE EMISSION CONTROL VALVE SET, see REPLACEMENT .
- REMOVE INTAKE AIR SURGE TANK, see REPLACEMENT .
- REMOVE INTAKE MANIFOLD
- Disconnect the fuel pipe No. 1.
- Remove the EFI fuel pipe clamp.
- Pinch the tube connector and then pull out the fuel pipe No. 1.
- Disconnect the fuel pipe No. 1.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
