Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Lexus LS 430FACTORY OEM SERVICE PROCEDURE
Fuel System (1GR-FE): Precaution
WARNING: This page is about a different car, the 2004 Toyota 4Runner. However, it is still accessible from the selected car via links, so may be relevant.
- PRECAUTION
- Before starting on the work for the fuel system inspection and repair, disconnect the negative (-) terminal cable from the battery.
- Do not smoke or work near fire when handling the fuel system.
- Keep gasoline away from rubber or leather parts.
- WORK FOR PREVENT GASOLINE FROM SPILLING OUT CAUTION:
- Take precaution for preventing gasoline from spilling out before removing the fuel system parts.
- As there is the remained pressure in the fuel line after working for prevent gasoline from spilling out, prevent it from splashing inside the vehicle compartment by covering them with a shop rag.
- Remove the circuit opening relay from the engine room relay block.
- Start the engine. After the engine stopped, turn the ignition switch OFF.
HINT:
There is a case that DTC P0171 (system to lean) is output.
- Check that the engine does not start.
- Remove the fuel tank cap, and let the air out of the fuel tank.
- Disconnect the negative (-) terminal cable from the battery.
- Reinstall the circuit opening relay.
- FUEL SYSTEM
- When disconnecting the high fuel pressure line, a large amount of gasoline will spill out, so observe these procedures.
- Disconnect the fuel pump tube.
- Drain the fuel remained inside the fuel pump tube.
- In order to prevent the disconnected fuel pump tube from damaging and foreign objects being mixed into cover them with a vinyl bag.
- Put a container under the connection.
- Observe these precautions when removing and installing the injectors.
- Never reuse the O-ring.
- When placing the new O-ring on the injector, do not damage the O-ring.
- Coat the new O-rings with spindle oil or gasoline before installing. Do not use engine oil, gear oil or brake oil.
- Install the injector to the delivery pipe and lower intake manifold as shown in the illustration.NOTE: Before installing the injector, must apply spindle oil or gasoline on the place where a delivery pipe or cylinder head contacts the O-ring of the injector.
- When disconnecting the high fuel pressure line, a large amount of gasoline will spill out, so observe these procedures.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
