2003 Lexus LS 430FACTORY OEM SERVICE PROCEDURE

Problem Symptoms Table

WARNING: This page is about a different car, the 2005 Toyota 4Runner. However, it is still accessible from the selected car via links, so may be relevant.
PROBLEM SYMPTOMS TABLE - WARNING LIGHTS

Symptom Suspected Area
Charge warning light does not come on.
  1. Generator (2UZ-FE)

    Generator (1GR-FE)

  2. Wire Harness or Connector
  3. Combination Meter Assy
Brake warning light does not come on.
  1. Parking Brake Switch
  2. Brake Fluid Level Warning Switch
  3. Wire Harness or Connector
  4. Brake Actuator Assy (ABS)
  5. Combination Meter Assy
Brake warning light does not go off.
  1. Parking Brake Switch
  2. Brake Fluid Level Warning Switch
  3. Wire Harness or Connector
  4. Brake Actuator Assy (ABS)
  5. Combination Meter Assy
Airbag warning light does not come on.
  1. Wire Harness or Connector
  2. Airbag Sensor Assy Center
  3. Combination Meter Assy
Airbag warning light does not go off.
  1. Wire Harness or Connector
  2. Airbag Sensor Assy Center
  3. Combination Meter Assy
Open door warning light does not come on.
  1. Door Courtesy Lamp Switch
  2. Wire Harness or Connector
  3. MPX Body ECU
  4. Combination Meter Assy
Fuel level warning light does not come on.
  1. Fuel Sender Gauge Assy
  2. Wire Harness or Connector
  3. Combination Meter Assy
Oil pressure warning light does not come on.
  1. Oil Pressure Switch
  2. Wire Harness or Connector
  3. Combination Meter Assy
A/T oil temp, warning light does not come on.
  1. Wire Harness or Connector
  2. ECM (2UZ-FE) ECM (1GR-FE)
  3. Combination Meter Assy
Seat belt warning light for driver's seat does not come on.
  1. Front Seat Inner Belt Assy (Driver Side)
  2. Wire Harness or Connector
  3. Combination Meter Assy
Fig 1: Problem Symptoms Table - Indicator Lights (1 Of 3)
G02574233Courtesy of Β© TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.