Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Lexus LS 430FACTORY OEM SERVICE PROCEDURE
How To Proceed With Troubleshooting
WARNING: This page is about a different car, the 2005 Toyota 4Runner. However, it is still accessible from the selected car via links, so may be relevant.
HINT:
Troubleshoot in accordance with the procedures in the following examples.
- VEHICLE BROUGHT TO WORKSHOP
Go to next step.
- CUSTOMER PROBLEM ANALYSIS CHECK AND SYMPTOM CHECK (See CUSTOMER PROBLEM ANALYSIS CHECK
)
Go to next step.
- PROBLEM SYMPTOMS TABLE
Go to next step.
- PERFORM TROUBLESHOOTING
- PRE-CHECK
- Circuit inspection (See AUTO UP/DOWN FUNCTION DOES NOT OPERATE - POWER WINDOWS DO NOT OPERATE AT ALL )
Go to next step.
- ADJUST, REPAIR OR REPLACE
Go to next step.
- RESET POWER WINDOW MOTOR
- If any of the power window switch illuminations is blinking after repair, reset the power window.
- Turn the ignition switch ON.
- Open the driver side door glass.
- Fully pull up the AUTO switch of the power window master switch until the door glass is fully closed.
- Check that the AUTO UP/DOWN function operates normally.
Go to next step.
END
- If any of the power window switch illuminations is blinking after repair, reset the power window.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
