2003 Lexus LS 430FACTORY OEM SERVICE PROCEDURE

Torque Specification

WARNING: This page is about a different car, the 2005 Toyota 4Runner. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATION

Part Tightened N.m kgf.cm ft.lbf
Tie rod end lock nut 88 897 65
Shock absorber piston rod x Suspension support sub-assy 25 260 18
Shock absorber (upper) x Frame 64 650 47
Shock absorber (Reas) bracket x Frame 29 300 21
Stabilizer link x Steering knuckle 70 710 52
Hub nut 112 1,140 83
Shock absorber x Lower arm 135 1,380 100
Upper arm x Steering knuckle arm 110 1,120 81
Skid control sensor x Upper arm 13 130 9 ft.lbf
Upper arm x Body 115 1,170 85
Lower arm x Suspension cross member 135 1,380 100
Lower arm x Lower ball joint attachment 140 1,430 103
Lower ball joint attachment x Steering knuckle arm 225 2,290 166
Stabilizer bracket x Body 40 410 30
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.