Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Lexus LS 430FACTORY OEM SERVICE PROCEDURE
Section 372 (Interior Light System)
WARNING: This page is about a different car, the 2002 Toyota Prius. However, it is still accessible from the selected car via links, so may be relevant.
- Service Precautions
- Precaution
- Troubleshooting
- Interior Light System
- Location
- Inspection
- Step 1 - Inspect Front Personal Light Continuity
- Step 2 - Inspect Interior Light Continuity
- Step 3 - Inspect Door Courtesy Switch Continuity
- Step 4 - Inspect Licence Plate Light Continuity
- Step 5 - Inspect Luggage Compartment Door Courtesy Switch Continuity
- Step 6 - Inspect Luggage Compartment Light Continuity
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.