Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Section 295 (Cruise Control Systems): Description
System Outline :
The cruise control system is a constant vehicle speed controller in which control of the switch on the instrument panel makes it possible to automatically adjust the opening of the engine throttle valve without depressing of the accel pedal.
- Set OperationÂ
:
When the ON-OFF SW is turned on, the system starts indicator light in the combination meter.
- Set Speed ControlÂ
:
When the "-/SET SW" is operated with the cruise control main SW turned on during travelling, the constant vehicle speed is controlled
- Coast ControlÂ
:
When the "-/SET SW" is kept turned on during cruise control travelling, the engine control module controls the throttle valve to decelerate the vehicle. Every time the "-/SET SW" is turned on instantaneously, the vehicle speed is decelerated approximately 1.5 km/h.
- Accel ControlÂ
:
When the + RES SW is kept turned on during cruise control travelling, the engine control module controls the throttle valve to accelerate the vehicle. Every time the. + RES SW is turned on instantaneously, the vehicle speed is accelerated approximately 1.5 km/h.
- Resume ControlÂ
:
When the vehicle speed is within the low speed limit (Approximately 40 km/h, 25 mph) if the cruise control is cancelled, use of the + RES SW accelerates the vehicle to the speed level used before canceling the cruise control.
- Manual Cancel MechanismÂ
:
If any of the following signals is input during cruise, the cruise control is cancelled.
- The stop light SW is turned on.
- The CANCEL SW is turned on.
- The ON-OFF SW is turned off.
- Auto Cancel FunctionÂ
:
If any of the following conditions is encountered, the cruise control is automatically cancelled.
- The stop light SW wiring is faulty or short-circuited.
- The vehicle speed signal is faulty.
- The electronically controlled throttle malfunctions.
- Overdrive Control FunctionÂ
Overdrive is sometimes cut off on gradients during cruise control driving. When end of climbing gradient is determined by throttle opening degree information after overdrive is canceled, control is reset to overdrive condition after overdrive resetting timer operation. Also, when overdrive is cut off during accelerator resuming control, control is reset to overdrive condition when accelerator resuming control is finished.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
