Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Lexus LS 430FACTORY OEM SERVICE PROCEDURE
Starter Specifications
WARNING: This page is about a different car, the 2004 Toyota 4Runner and 2003 Toyota 4Runner. However, it is still accessible from the selected car via links, so may be relevant.
STARTER SPECIFICATIONS (1.4 Kw)
| Application | In. (mm) | ||
|---|---|---|---|
| Brush Length | |||
| Standard | .610 (15.5) | ||
| Minimum | .394 (10) | ||
| Commutator | |||
| Diameter | |||
| Minimum | 1.142 (29) | ||
| Standard | 1.181 (30) | ||
| Runout | .0020 (.05) | ||
| Undercut Depth | |||
| Standard | .024 (.6) | ||
| Minimum | .008 (.2) | ||
| Spring Load | |||
| Installed Minimum | 2.7 Lb. (1.2 Kg.) | ||
| Installed Standard | 4.0-5.3 Lb. (1.79-2.41 Kg.) | ||
STARTER SPECIFICATIONS (1.6 Kw)
| Application | In (mm) | ||
|---|---|---|---|
| Brush Holder Length | |||
| Standard | .354 (9.0) | ||
| Minimum | .157 (4.0) | ||
| Commutator | |||
| Length | |||
| Standard | .122 (3.1) | ||
| Maximum | .150 (3.8) | ||
| Runout | .002 (.05) | ||
| Snap Ring End Gap | .197 (5.0) | ||
STARTER SPECIFICATIONS (2 Kw)
| Application | In. (mm) | ||
|---|---|---|---|
| Brush Length | |||
| Standard | .591 (15) | ||
| Minimum | .354 (9) | ||
| Commutator | |||
| Diameter | |||
| Minimum | 1.339 (34) | ||
| Standard | 1.378 (35) | ||
| Runout | .0020 (.05) | ||
| Undercut Depth | |||
| Standard | .028 (.7) | ||
| Minimum | .008 (.2) | ||
| Shunt Coil Resistance | 1.5-1.9Ξ© at (68Β° F) (20Β° C) | ||
| Spring Load | |||
| Installed Minimum | 2.7 Lb. (1.2 Kg.) | ||
| Installed Standard | 4.8-6.2 Lb. (2.2-2.8 Kg.) | ||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
