Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Lexus IS 300 Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Limit Switch & Pulse Switch
Check that the master switch assembly automatic light flashes (for 45 seconds after the starter switch has been turned from ON to OFF with the driver's door opens) under the condition of KEY off operation.
- Limit Switch Malfunction -Β Even though the glass goes down from the fully closed position, the power window regulator switch assembly does not detect a change in limit switch signal within 2 seconds after the operation has started. See Fig 1.
- Pulse Sensor Malfunction -Β Even though the glass goes down from the fully closed position, the power window regulator switch assembly does not detect a change in pulse switch signal within 2 seconds after the operation has started.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
