2003 Lexus GX 470FACTORY OEM SERVICE PROCEDURE

Circuit Opening Relay

  1. To test relay continuity, use ohmmeter to check for continuity and no continuity between specified terminals on C/OPN relay. See Fig 1. If there is no continuity between terminals No. 1 and 2, or there is continuity between terminals No. 3 and 5, replace relay.
  2. Apply battery positive voltage across terminals No. 1 and 2. Using an ohmmeter, check that there is continuity between terminals No. 3 and 5. If there is no continuity, replace relay.
Fig 1: Identifying Relay Terminals
G00248001Courtesy of Β© TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.