2003 Lexus GS 430FACTORY OEM SERVICE PROCEDURE

Service Data

SFI SERVICE SPECIFICATIONS (3UZ-FE)

Fuel pressure regulator Fuel pressure 304 - 343 kPa (3.1 - 3.5 kgf/cm2 , 44-50 psi)
Fuel pump Resistance at 20°C (68 °F) 0.2-3.0 ohm
Injection Resistance at 20°C (68°F) 13.4-14.2 ohm
Injection volume 60 - 73 cm3 (3.7 - 4.5 cu in.) per 15 seconds
Difference between each cylinder 13 cm3 (0.8 cu in.) or less
Fuel leakage 1 drop or less per 12 minutes
Air flow meter Resistance (THA - E2) at -20 ° C (-4 ° F) 13.6-18.4 kohm
at 20°C (68°F) 2.21 - 2.69 kohm
at 60°C (140°F) 0.49 - 0.67 kohm
Throttle body Throttle body fully closed angle 4°
Throttle position sensor Resistance (VC - ETA) at 20°C (68°F) 1.25-2.35 kohm
Accelerator pedal position sensor Resistance (Vcp1 - Ep1 ), (Vcp2 - Ep2 ) at 20°C (68°F) 1.5-6.0 kohm
Throttle control motor Motor resistance at 20°C (68°F) 0.3-100 ohm
Camshaft timing oil control valve Resistance at 20°C (68°F) 6.9-7.9 ohm
VSV for EVAP Resistance at 20°C (68°F) 30 - 34 ohm
VSV for ACIS Resistance at 20°C (68°F) 33 - 39 ohm
VSV for canister closed valve (CCV) Resistance at 20°C (68°F) 24 - 30 ohm
VSV for pressure switching valve Resistance at 20°C (68°F) 33 - 39 ohm
ECT sensor Resistance at-20°C (-4°F) 10-20 kohm
0°C(32°F) 4-7 kohm
20°C (68°F) 2-3 kohm
40°C (104°F) 0.9 - 1.3 kohm
60°C (140°F) 0.4-0.7 kohm
80°C (176°F) 0.2-0.4 kohm
Vapor Pressure sensor Power source voltage 4.5-5.5 V
Heated oxygen sensor Heater coil resistance at 20°C (68°F) 11 -16ohm
VVT sensor Resistance Cold 835 - 1,400 ohm
Hot 1,060 - 1,645 ohm
Fuel cut rpm Fuel return rpm 1,400 rpm
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.